Mafell ERIKA 70, Перевод оригинальной инструкции по эксплуатации

Страница: 45 / 286

-45-
6.2 Machine care
The sliding and rolling parts must be occasionally
cleaned of chips and dust with a suitable vacuum
cleaner. Occasional spraying with a commercially
available lubricant (e.g. Caramba) facilitates sliding of
the parts.
In order to avoid too large a temperature rise of the
motor check occasionally that there is no dust deposit
on its surface. If dirty, the filter housing on the motor
must be cleaned (see 4.9).
6.3 Storage
If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
7 Troubleshooting
Danger
Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Some of the most frequent defects and their causes are listed in the following chart. If case of other defects,
please contact your dealer or the MAFELL customer service.
Defect Cause Elimination
Machine cannot be switched on No mains voltage Check power supply
Mains fuse defective Replace fuse
Carbon brushes worn Take the machine to a MAFELL
customer service shop
Machine switches off
automatically during idling Mains failure Check mains-side back-up fuses
The machine does not restart due
to the installed undervoltage
protection and must be turned on
again after power has returned
Machine stops while cutting is in
process Mains failure Check mains back-up fuses
Machine overloaded Reduce feed speed
Workpiece jams when feeding Blunt saw blade Hold workpiece and turn motor off
immediately. Then exchange the
saw blade
Stop rail of the universal and/or
the multi-function stop is not
parallel to the saw blade Readjust the stop rail, see chapter
5.10
Burn marks on the cut surfaces The saw blade used is unsuitable
for the task or blunt Replace saw blade