-37-
3.6
Instructions on service and maintenance
-
Before beginning maintenance and repair work,
pull the connecting cable out of the socket outlet.
-
Only allow an electrician to carry out work on the
electrical parts of the machine.
-
Damaged cables or plugs must be immediately
replaced. Replacement may only be carried out by
Mafell or an authorised MAFELL service workshop
in order to avoid safety hazards.
-
The MAFELL customer service must replace the
tabletop, if the table slit has been sawed
exceedingly.
-
Only original MAFELL spare parts and accessories
may be used. Otherwise, the manufacturer will not
accept any warranty claims and cannot be held
liable.
4
Setting / Adjustment
4.1
Installation / Transport
The machine is delivered in a transportation box.
Check the machine for possible transport damages.
Damage to the packing material may already be
indicative of improper transport. Immediately notify
your machine dealer of transport damages.
The following parts are packed loosely and must be
installed or attached to the machine before start-up:
-
Upper saw guard
-
Extraction hose
-
Branch pipe (connection of upper and lower
extraction connection)
-
Universal stop
-
Pushing stick
-
Clamping piece
Proceed as follows for assembly:
www.mafell.de/erika
Upper saw guard
Unscrew the wing bolt 2 (Fig. 2 - page 3)
counter clockwise up to the stop. Press
this wing bolt and push the saw guard 1
horizontally onto the riving knife/splitter 3.
Make sure that the guide piece of the wing
bolt is firmly engaged in the drilling of the
riving knife/splitter when you release the
wing bolt. Retighten the wing bolt 2.
The drilling at the rear left of the
longitudinal side of the machine into which
the saw guard can be hooked with or
without the riving knife/splitter is intended
for short-term storage of the upper saw
guard with the riving knife/splitter removed
(e.g. for plunge cuts). For transport
purposes, the upper saw guard can also
be attached to the mounting plate 50 (Fig.
5 - page 3) of the left rear foot.
Extraction hose and branch pipe
First of all, attach the branch pipe 4 (Fig. 5
- page 3) to the extraction connection on
the chip duct. Connect the extraction
connection on the upper saw guard to the
extraction hose 5. Push this hose onto the
appropriate connection of the branch pipe.
Universal stop
The installation of the universal stop is
described in chapter 5.10.
Pushing stick / pushing handle
You can store the supplied pushing stick 6
(Fig. 5 - page 3) on the left longitudinal
side of the machine in the bracket 42
provided for this purpose (Fig. 5 - page 3)
and on the cast-on lateral transport handle
7.
For storing the pushing handle (special
accessory), use the drilling on the front
right on the longitudinal side of the
machine, in which you can insert the
pushing handle. According to your
requirements, you can attach a pushing
stick to the pushing handle. For this
purpose, place the handle onto the
pushing stick and press both tips into the
timber. Then press on the wing bolt and
screw it in.