MAESTRO WIRELESS SOLUTIONS
| Network
120
E-SERIES | USER MANUAL VERSION 2.0.1
http://support.maestro-wireless.com
management
configuration.
Use broadcast flag
Check to use the broadcast flag.
This flag is generally used by the ISP’s.
Use
default
gateway
Click to configure a default gateway route.
None of the gateway routes are configured by
default.
Use DNS server
advertised by peer
Allows advertising the DNS server address.
Use DNS server advertised by peer for WAN
interface is checked by default.
If unchecked, the advertised DNS server addresses
are ignored.
Use
gateway
metric
Enter the gateway metric.
The Load Balancer uses these Metric values to
determine priority of a WAN.
The default metric is 4.
Client ID to send
when requesting
DHCP
Enter the Client ID that shall be sent when
requesting DHCP.
Vendor Class to
send
when
requesting DHCP
To allocate DHCP IP Addresses based on Vendor
Class.
Override
MAC
address
Click to override the default MAC Address for the
WAN Interface.
On factory reset, it will be set to default MAC
address.
Overrride MTU
Click to override the default MTU value (Maximum
Transmission Unit)
The default MTU is 1500.
Table 11.1-27: Advanced Configuration for WWAN Interface
