madur electronics maMoS 100, Руководство пользователя, Страница: 45 / 96

www.madur.com Manual maMoS 100/200/300/400
If the operating system will not allow to select the FAT-16 system, the card can be
formatted differently. Please follow the instructions below to format the card:
1. Run the command line terminal – execute program: C:\Windows\Sys-
tem 32\cmd.exe
2. Enter command: format X: /FS:FAT
where X is a card's drive letter.
3. Confirm the selection of 64KB clusters
4. Optionally, enter the cards label.
5.5. Updating the monitor's firmware.
The modular design of the monitor and the fact that its construction is based on
the latest technological achievements enable the user to improve the functionality of the
device by changing its software. As the products are systematically up-
graded, new programs for operating the devices (so-called firmware) are continually im-
proved. The firmware is available from the company's website ( www.madur.com ).
5.5.1. The procedure of updating firmware
To update the firmware successfully the WSD software from the Analog Devices ®
company should be installed. The software is recorded on the CD provided with the monit-
or in the catalogue: x:\service_wsd_v6.7 (where: x: - stands for the letter of the CD-ROM
drive, and v6.7 indicates the program's version – the software version can be different on
the provided CD). During the installation process the user should follow the instructions
given in the installation program.
Updating the firmware should be performed as follows:
1. The monitor should be switched off.
2. The top of the casing should be opened (see Picture 21. – section 4.1.1. )
and the metal cover should be removed (Picture 47. and Picture 48.).
3. The CPU should be localised (the upper rightmost slot) and a short-circuit
made on the two upper pins of the five pin connector with a 2.54 mm jumper
(Picture 49.).
4. The monitor should be connected to the computer using the RS232C or USB
socket.
45