DMK-1 Installation Guide
REV
–
1.0
[34-2900-0065-9 ]
9
|
P a g e
3.5
Mounting the Detector
3.5.1
Run the wiring through the strain relief. Twist the outer cap of the strain relief clockwise to compress the
gasket material around the wiring.
3.5.2
Connect the wiring according to the instructions provided for the detector.
3.5.3
Install the gas detector onto the top of the four (4) standoffs. Secure it in place using the four (4) remaining
machine screws.
Important:
•
Be sure that there is a good seal between the DMK-1 and the duct surface around the sampling and exhaust
tubes to ensure appropriate air flow through the DMK-1 and to the detector.
3.5.4
Test the installed detector as described in the detector’s User Manual.
3.5.5
Replace the cover and tighten the cover screws.
