E2
TECHNICAL
DETAILS
SAFETY
PRECAUTIONS
LIMITED
WARRANTY
EXPLODED AND
PARTS LIST
INSTALLATION INSTRUCTIONS
OPERATION
INSTRUCTIONS
STRUCTURE FEATURES
INSTALLATION INSTRUCTIONS
Prepare tools for installation
For overhead ceiling and wall mounting
：
the installation height should not exceed 3m(10 feet)
above the floor.
If the reel you have purchased does not have hose included, you will need to purchase and
attach. Refer to specifications to determine appropriate hose and size.
1. The reel base has four 7/16"(or 11mm) drilled holes for mounting on a suitable flat surface.
Figures 1.1 to 1.2 is a template showing the correct location of the 4 mounting holes in the
base.
2. The reel is supplied with a hose guide roller bracket. The bracket position may require
repositioning depending on the selected reel mounting position. Figure 2.1 shows “Typical
Mounting Positions”. If bracket position needs to be changed, do the following:
(1) Pull out some hose and let reel latch.
(2) Remove side cover and guide arm.
(3) Rotate guide roller bracket to correct position, replace bolts and tighten.
3. Using the four holes in the base, mount the reel in the desired location. Be sure to use
appropriate hardware and tighten securely.
4. Apply Teflon tape or pipe sealant to supply line threads, attach to reel inlet and tighten. The
other end of incoming line can now be connected to desired supply source.
5. If hose has been supplied with reel: Apply Teflon tape or pipe sealant to outlet fitting on reel
hose, then attach to desired tool, or nozzle. Check connection for leakage, also check hose
reel for correct operation. (Details see Operation section.)
6. If hose stopper adjustment is required, pull hose from reel and allow to latch at desired
length. Loosen stopper bolts and slide stopper to a position close to the hose guide. Tighten
stopper bolts, and unlatch the reel.
Floor
Ceiling
Wall
