Page
36
of
63
Limit Switch
This section will instruct the correct procedure on how to remove and replace the Limit
Switch Block.
Removal
Step 1 - Remove external covers off the Hoist. (refer to section 9.1)
Step 2
–
Remove the PCB from the Hoist. (refer to section 9.2)
Step 3
–
Remove the Battery from the battery brackets. (refer to section (9.3)
Step 4
–
Remove the Lift Motor. (Refer to section 9.5)
Step 5
–
Remove Lift Tape. (Refer to section 9.10)
Step 6
–
Remove Bottom Cover. (Refer to section 9.7)
Step 7
–
Using a slotted screw driver, prise the grommet (arrowed) from the chassis.
Step 8
–
Guide the Limit Switch Wires and Connector into the Chassis.
Step 9
–
Use a 3mm Allen Key to remove the four Screws securing the Limit Switch Block.
Содержание TX440 Advanced PT
Страница 10: ...Page 10 of 63...
Страница 11: ...Page 11 of 63...
