995051 – Revision A
Page 29 of 36
9.10 – Rear Castor
Within this section it will explain the correct procedure on removing and reinstalling the
Rear Castor for servicing procedures or replacement.
Removal
Step 1 - Place the Hoist in its side for easier service – Gently rest the Hoist on its side to avoid
damage such as paint scratching.
Step 2 –
(Rev A) To release the Rear Castor, place a 6mm Allen Key into the countersunk bolt and use
a 12mm Spanner on the underside of the Castor as shown and loosen.
(Rev B) To release the Rear Castor, place a 6mm Allen Key into the countersunk bolt and use
a 17mm Socket on the underside of the Castor as shown and loosen.
Step 3 – Remove the Castor from the securing bolt as shown.
.
Refitting / Replacement
Step 4 - Refitting is a reversal of the removal process noting the following point:
A)
Ensure that the Castor is secured tightly, there should be no play after fastening.
B)
Ensure the Castor rotates freely.
C)
(Rev A) Apply Loctite 243 to the bolt thread.
Rev A
Rev B
Rev A
Rev B