Mack V-MAC IV, Руководство оператора

Страница: 74 / 133

66 V-MAC Co-Pilot Operator's Manual
Idle Shutdown
This feature will shut off the engine after it has been idle for a specified period. The
time period is customer programmable using the VCADS software. An alarm will
warn 30 seconds (a programmable time frame) before the engine will shut down. The
idle shutdown override switch can be used during this 30 second period to override
idle shutdown or the service brake or accelerator pedal (AP) can be applied. Once
the engine shuts down, the engine can be re-started by turning the ignition key to
the Start position.
If Idle Shutdown with sleeper mode is enabled, the shutdown can be cancelled if the
idle shutdown override switch, service brakes, or AP are pressed
while the Shutdown
Indicator is on . Idle shutdown will be active again after the vehicle has been moved
and parked. Some options only allow sleeper mode if the ambient air temperature
(AAT) requires heating or air conditioning. If the ambient temperatures are out
of range, the amber electronic malfunction indicator will illuminate and the idle
shutdown function can be overridden. If AAT is within range, idle shutdown remains
active and the red shutdown indicator will illuminate as a warning (refer to the
VCADS
User's Guide for more information about possible idle shutdown settings).
Note: Idle shutdown will not occur during an aftertreatment diesel particulate
filter (DPF) regeneration. If the idle shutdown timer requests a shutdown during
aftertreatment diesel particulate filter (DPF) regeneration, the engine will not shut
down until after regeneration has been completed.
Note: The California Air Resources Board (CARB) requires 2010 model year
vehicles to be equipped with engines having tamper-resistant software which limits
the time that the engine can idle at speeds above low idle (550–700 RPM). At speeds
above low idle, and with a power takeoff (PTO) engaged, idle time will be limited to 5
minutes, after which the engine will revert back to low idle. Vehicles equipped with a
Clean Idle engine are identified by a label which is affixed to the left front corner of
the hood on conventional models (CXU, CHU and GU), and the lower portion of the
driver's side door on cab-over models (MRU and LEU).
https://truckmanualshub.com/