Single-Port Power Analyzer
Quick Start Guide
Power Analyzer Overview
Connect LED
Active LED
Transmit LED
Power On LED
Power On/Off Switch
Ethernet Port
Voltage Probe
Current Probe
24V DC Input
110-240V AC Input
Input Power Connections
110-240V AC
Connect the supplied
110-240 Volt AC plug to
110-240 power located on
the machine where the
Power Analyzer is being
installed.
Neatly route any excess cable in available
cable trays. Use wire ties and self-
adhesive cable tie mounts to tidy your
installation.
Connect a user supplied Ethernet cable
to the rear of the Power Analyzer box
connecting the other end to the user
supplied network with internet access.
For WiFi installations please refer to the
Wifigurator Network Connection Guide for
connection instructions.
Make sure the 3-core power cable is
properly connected to the rear of the
Power Analyzer and the plug is connected
to 110-240V AC power or 24V DC power
as selected during installation. Turn the
rocker power switch to the ‘ON’ position.
Immediately, the LEDs corresponding to
'Power' will light. After approximately 30
seconds, the 'Connect' and 'Active' lights
will turn on. If not, check power connec-
tions from the back of the Power
Analyzer box to the supplied power.
QC-INSTALL-PA-001-0817
24V DC
If using 24V DC supply to
power the Power Analyzer
wire the red lead to 24V DC
and the black lead to 0V DC.
STEP 4
NOTE
: The 3-core
power cable will be
connected to the 3-pin
brass connector on
the rear of the Power
Analyzer Unit upon
shipment.
221 E. Thomas Avenue Baltimore, MD 21225 +1-443-457-1165 www.machinesense.com
Download the
MachineSense
Wifigurator
App from the
App Store or
the Play Store.
AC plug adapter
(shown) may be
required. Not included.
Mounting Bracket Options
Install the Power Analyzer box into the control cabinet
of the machine/component to be monitored. The feet
can be used to secure the Power Analyzer to the cabinet
or can be replaced with the supplied bracket. See the
mounting bracket options on the last panel. Be certain
to consider the cord/ connection locations before
affixing the box.
WARNING:
Voltage hazard
Before making electrical
connections always disconnect and
lock out the main power sources to
prevent injury from unexpected
energization or start-up. Electrical
connections should be made only by
qualified personnel.
WARNING: Improper
installation, operation, or
servicing may result in
equipment damage or personal injury
This equipment should be installed,
adjusted, and serviced by qualified
electrical technicians.
All wiring and disconnects should be
installed by a qualified electrical techni-
cian in accordance with electrical codes
in your region.
