MacDon Swath Compressor, Руководство по эксплуатации и запасным частям

Страница: 49 / 90

215953
41
Revision A
1021931
A B
C
Figure 3.19: HPT Display
Display functions
•
As the swath compressor moves up or down, target
value (A) changes, windrower icon (B) appears as an outline,
and swath compressor icon (C) flashes.
•
Windrower icon (B) is solid when the target height is
achieved.
•
Value (A) is 0, and image (B) is an outline with the swath
compressor fully raised.
•
Icon (B) is not visible and automation is disabled without a
header attached. Swath compressor height can still be
adjusted.
Swath compressor automated functions: header engaged
•
The swath compressor lowers to target height at a ground speed higher than 2.5 km/h (1.6 mph).
•
The swath compressor fully rises as the ground speed transitions through 1.6 km/h (1 mph) during deceleration.
•
The swath compressor fully rises when the header is disengaged at a ground speed higher than 1.6 km/h (1 mph).
•
An IMPORTANT message to raise the swath compressor appears on the HPT accompanied by a tone when the GSL is
moved out of PARK in engine-forward mode if the swath compressor is not fully raised.
Engage the swath compressor lock when the swath compressor is not in use, or when the windrower is in engine-forward
mode. For instructions, refer to
3.3.6 Locking and Unlocking Swath Compressor, page 44 .
3.3.2 Setting up Swath Compressor
Operate the windrower in crop and use the following procedure to determine the settings for the crop and crop conditions.
CAUTION
Park on a level surface with the ground speed lever (GSL) in the PARK position and the steering wheel in the locked
(centered) position. Wait for the Harvest Performance Tracker (HPT) to beep and display a red P symbol to confirm that
the parking brake is engaged.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, stop the engine and remove the key
from the ignition before leaving the operator
’
s seat.
OPERATION