MacDon Swath Compressor, Руководство по эксплуатации и запасным частям

Страница: 44 / 90

215953
36
Revision A
3.2 Calibrating Position Sensor
The swath compressor position sensor must be calibrated when the system is first installed.
NOTE:
To calibrate the position sensor, the swath compressor must be attached to the windrower, but it can be calibrated with or
without a header attached. This procedure shows the calibration process with both the swath compressor and header
attached to the windrower.
The Harvest Performance Tracker (HPT) recognizes the attachment(s) and determines the systems that require calibration.
The following sensors will be calibrated depending on the attachment(s):
•
Header height
•
Header angle
•
Header float left
•
Header float right
•
Reel height
•
Reel fore-aft
•
Swath compressor height
DANGER
Ensure that all bystanders have cleared the area.
To calibrate the sensors, follow these steps:
1. Start the windrower, and engage the header.
1018932
A
B
C
Figure 3.9: Opening the Main Menu
2. Press soft key 5 (A) to open the main menu.
NOTE:
Calibrations MUST be performed with the engine running.
Some calibrations will not be available with the engine off.
3. Use HPT scroll knob (B) or the ground speed lever (GSL)
scroll wheel (not shown) to highlight SETTINGS icon (C).
4. Press HPT scroll knob (B) or the GSL SELECT button (not
shown) to activate the settings menu options.
OPERATION