MacDon R85, Руководство по установке, Страница: 15 / 42

3 Installation Instructions
To install the Bevel Gearbox kit, follow these steps:
CAUTION
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
1. Lower the header/mower conditioner fully.
2. Shut down the engine and remove the key.
3.1 Removing Hazard Light
The left-hand hazard light and lamp bracket must be removed before the new gearbox can be installed. To
remove them, follow these steps:
1. Disconnect lamp wires from wiring harness at
connectors (A).
2. Remove four bolts (B) and remove lamp assembly (C)
from header/mower conditioner. Retain bolts and lamp
assembly for reinstallation.
Figure 3.1: Hazard Light
147974
9
Revision B