MacDon R216, Руководство оператора

Страница: 151 / 214

215026
139
Revision A
Removing Cutterbar Spindle Shear Pin
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
CAUTION
Disc blades have two sharp cutting edges that can cause serious injury. Exercise caution and wear gloves when working
with blades.
1. Raise the header fully.
2. Shut off the engine, and remove the key from the ignition.
3. Engage the windrower lift safety props. For instructions, refer to 3.2.1 Engaging and Disengaging Header Safety Props
–
M1240 Windrower, page 20 .
1030429
A
Figure 4.135: Cutterbar Curtain
4. Open cutterbar curtain (A). For instructions, refer to 3.6.1
Opening Cutterbar Curtain, page 45 .
5. Clean any debris from the work area.
1028264
A
B
C
Figure 4.136: Cutterbar Disc and Driven Drums
6. Refer to the applicable disc removal procedure for the type
of disc with a broken shear pin:
•
To remove cutterbar disc (A), refer to Removing
Cutterbar Discs, page 90 .
•
To remove left driven drum (B), refer to Removing Left
Driven Drum and Driveline, page 126 .
•
To remove right driven drum (C), refer to Removing
Right Driven Drum and Driveline, page 132 .
MAINTENANCE AND SERVICING