214075
43
Revision A
5
Installing Options
Install options (if supplied with shipment) in accordance with the instructions supplied with each kit.
5.1
Installing Tall Crop Divider
To install the tall crop divider kit (MD #B5800), follow these steps:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator’s seat for any reason.
1.
Lower header/mower conditioner fully.
2.
Stop the engine, and remove the key.
3.
Unpack kit.
4.
Open cutterbar doors.
Figure 5.1: Tall Crop Divider Kit (Left Shown –
Right Opposite)
5.
Remove the four bolts (A) from the divider (B).
NOTE:
Mounting holes in rotary disc header should be vacant. If
necessary, remove fasteners.
Figure 5.2: Tall Crop Divider (Left Shown –
Right Opposite)
6.
Position left divider (B) on rotary disc header left front
corner, and install with four bolts (A) and nuts in existing
holes. Tighten hardware.
7.
Repeat for right side.
8.
Close the cutterbar doors.
