MacDon R113, Руководство по установке

Страница: 21 / 36

215276
15
Revision A
3.2.2 Repositioning Conditioner Drive Speed Sensor
–
Model Year 2017
Follow these instructions to reposition the sensor for M205 Windrowers.
NOTE:
If the model year 2017 header has been updated with a model year 2018 style steel speed sensor and bracket, refer to
3.2.1 Repositioning Conditioner Drive Speed Sensor
–
Model Year 2018 and Later, page 13 .
1032994
A
B
A
F
D
G
E
C
Figure 3.19: Speed Sensor Assembly
–
Side View,
Model Year 2017
1. Adjust the following hardware until sensor (A) is aligned
with the top inside edge (B) of a long hole, and there is a
2
–
3 mm (1/16
–
1/8 in.) gap (C) between the pulley and
sensor (A). Make sure the sensor is parallel with the pulley.
2. Loosen hardware (D) securing sensor angle (E) to sensor
channel (G), and move sensor (A) outboard.
3. Loosen hardware (F) securing sensor channel (G) to the
header, and then move sensor (A) upwards.
4. Check the clearance between speed sender (A) and the
drive pulley. If necessary, adjust the sensor nuts to ensure
that there is a 2
–
3 mm (1/16
–
1/8 in.) gap (F) between the
speed sender and the pulley. Ensure the speed sender is
parallel with the pulley.
5. Tighten nuts (D) and (F) to 58 Nm (43 lbf·ft).
6. If necessary, adjust the wiring harness to ensure that it is
not too tight and that it clears the driveshield when the
driveshield is closed.
A
1032984
Figure 3.20: Left Driveshield
7. Close left driveshield (A). For instructions, refer to the
header operator
’
s manual or technical manual.
8. Proceed to 3.3 Installing Electrical Components, page 16 .
INSTALLATION INSTRUCTIONS