215333
227
Revision A
1008471
A
Figure 4.210: Bolt Securing Driveline to Gearbox
4.
Slide driveline shield cone away from gearbox.
5.
Loosen nut (A) so that taper pin threads are recessed inside
the nut.
6.
Tap nut (A) with a hammer to loosen the taper pin and
release driveline yoke from the shaft.
7.
Pull driveline off gearbox.
8.
Remove driveline guard if necessary. For instructions, refer
to
Removing Driveline Guards, page 250
Installing Primary Driveline
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
2.
Install driveline guard onto driveline (if previously removed). For instructions, refer to
Installing Driveline Guards, page
1019415
A
B
Figure 4.211: Primary Driveline
NOTE:
Before installing the driveline, refer to
to ensure proper orientation.
3.
Position U-joint (A) and grease fitting (B) as shown.
