![background image](http://html1.mh-extra.com/html/macdon/r1-series/r1-series_installation-instructions-manual_3196781044.webp)
214497
38
Revision D
3.13
Installing Cutterbar Deflectors
The cutterbar deflectors are used with roll conditioners only.
IMPORTANT:
Pull-Type only:
To avoid damage, cutterbar deflectors must
NOT
be used with the finger conditioner option.
1024786
A
B
C
Figure 3.69: Left Cutterbar Deflector Viewed from
Underside of Cutterbar
1.
Position left deflector (A) on the aft edge of the cutterbar,
and align slots in deflector (A) with the existing fasteners
and cutterbar plug.
2.
Install bolt (C) shared with the rock guard at the outboard
end of deflector.
3.
Secure the deflector to the cutterbar with three button
socket head M10 bolts (B) and lock nuts. Bolts are inserted
into the cutterbar from the bottom.
1024788
A
B
C
D
Figure 3.70: Right Cutterbar Deflector Viewed from
Underside of Cutterbar
4.
Position right deflector (A) on the aft edge of the cutterbar,
and install three button socket head M10 bolts (B) with lock
nuts. Bolts are inserted into the cutterbar from the bottom.
5.
Install bolt (C) shared with the rock guard at the outboard
end of the deflector.
6.
Align the right deflector with the left one at position (D)
and tighten bolts (B) to 54 Nm (40 lbf·ft) with a 17 mm
socket and an 8 mm hex key.