![background image](http://html1.mh-extra.com/html/macdon/r1-series/r1-series_installation-instructions-manual_3196781003.webp)
Introduction
The Ten-Disc Cutterbar kit (MD #259517) can be used to replace the cutterbar on a MacDon R116 Rotary Disc Header or
Rotary Disc Pull-Type; the Eight-Disc Cutterbar kit (MD #259518) can be used to replace the cutterbar on a MacDon R113
Rotary Disc Header or Rotary Disc Pull-Type.
This document explains how to install the kits. A list of parts included in the kits is provided in Chapter
.
Installation time
Installation of this kit will take approximately 6 hours.
Conventions
The following conventions are used in this document:
•
Right and left are determined from the operator
’
s position. The front of the disc mower or header is the side that faces
the crop.
•
Unless otherwise noted, use the standard torque values provided in the mower or header operator
’
s manual and
technical manual.
NOTE:
Keep your MacDon publications up-to-date. The most current version of this instruction can be downloaded from our
Dealer-only site (
) (login required).
NOTE:
This document is currently available in English only.
214497
i
Revision D