262391
153
Revision A
11. Close the cutterbar doors. For instructions, refer to
Closing Cutterbar Doors, page 27
Removing Large Driven Drums and Driveline
The large driven drum is on the left end of the cutterbar.
DANGER
To prevent injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and remove
the key from the ignition before leaving the operator
’
s seat or making adjustments to the machine. If the rotary disc
header is raised, always close the lock-out valves, and place blocks under the header. Never work on or beneath an
unsupported header.
DANGER
Ensure that all bystanders have cleared the area.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Position the rotary disc header at an appropriate height for the task.
2.
Shut down the engine, and remove the key from the ignition.
3.
If the rotary disc header is raised:
a.
Place blocks under each end, or just inside each end, of the cutterbar.
b.
Lower the rotary disc header onto the blocks.
c.
Shut down the engine, and remove the key from the ignition.
d.
Close the auxiliary lift cylinder lock-out valves. For instructions, refer to
3.2.1 Locking and Unlocking Auxiliary Lift
.
4.
Open the cutterbar doors. For instructions, refer to
3.4.1 Opening Cutterbar Doors, page 26
1011078
A
B
Figure 4.130: Vertical Drive Shield
5.
Remove four M10 hex flange head bolts (A) and remove
vertical driveshield (B).
