MacDon M205, Руководство оператора

Страница: 117 / 514

214603
97
Revision A
Setting the Return to Cut Mode
For more information on the Return to Cut feature, refer to 4.4.7 Return to Cut , page 208 .
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and Detaching
Headers, page 217 .
1. Turn ignition key to RUN, or start the engine.
1009974
C###
X###
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.84: M205 CDM Programming Buttons
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1009993
RETURN TO CUT MODE
HEIGHT & TILT
C###
X###
D
C
B
A
Figure 3.85: M205 Return to Cut Mode
4. Press SELECT (D) until RETURN TO CUT MODE? is
displayed on the upper line.
•
HEIGHT & TILT or HEIGHT ONLY will be displayed
on the lower line.
5. Press left (B) or right (C) arrows to select RETURN TO
CUT MODE. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
OPERATOR
’
S STATION