215104
149
Revision A
1011784
CXXX
EXXX
ACTIVATE FUNCTIONS?
NO/YES
B
A
Figure 4.117: Functions
5.
Press SELECT (B) until ACTIVATE FUNCTIONS? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
6.
Press right arrow (A) to select YES. Press SELECT (B).
CAUTION
Check to be sure all bystanders have cleared the area.
1011806
CXXX
EXXX
ACTIVATE HEADER HT
DOWN/UP
D
C
B
A
Figure 4.118: Header Height
7.
Press SELECT (D) until ACTIVATE HEADER HT is displayed on
the upper line.
•
DOWN/UP is displayed on the lower line.
8.
Press and hold left arrow (B) to lower header, or press and
hold right arrow (C) to raise header. Verify header is
functioning properly.
9.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next ACTIVATE FUNCTION.
4.9.2
Testing the Reel Up/Down Activate Function Using the Cab Display Module
NOTE:
•
This procedure is for draper headers only.
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1011772
C###
E###
WINDROWER SETUP?
NO/YES
A
B
Figure 4.119: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (B) on the CDM to enter
programming mode. Press SELECT (B).
•
WINDROWER SETUP? is displayed on the upper line.
