215104
114
Revision A
4.3.10
Activating the Rotary Disc Header Drive Hydraulics
NOTE:
This procedure requires installation of the optional Rotary Disc Header Drive Hydraulics (MD #B5510).
For more information, refer to the rotary disc header operator
’
s manual.
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.37: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.38: Rotary Disc Hydraulics
4.
Press SELECT (C) until DISC BLK INSTALLED? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (B) to select YES. Press SELECT (C).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (C) to proceed to next WINDROWER SETUP action.
4.3.11
Setting the Header Cut Width
The header sends an electrical signal to the windrower to produce a header ID; however, the cut width will always default
to the smallest header size available for each header type. For example, A Series Auger Headers come in 4.3, 4.9, and 5.5 m
(14, 16, and 18 ft.) sizes, but the cut width will default to 4.3 m (14 ft.). Adjust setting to your specific header size.
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
Header cut width is set to less than the actual header width in order to accurately measure the number of acres cut.
1.
Turn the ignition key to RUN, or start the engine.
