MacDon M155, Инструкции по разгрузке и сборке

Страница: 175 / 272

215015
149
Revision A
4.9.8 Testing the Reel Fore-Aft Activate Function Using the Cab Display Module
NOTE:
•
The header MUST be attached to windrower to perform this procedure.
•
The engine MUST be running to perform this procedure.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.139: CDM Programming Buttons
1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
1009288
CXXX
MXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 4.140: Diagnostic Functions
3. Press SELECT (B) until DIAGNOSTIC MODE? is displayed in
upper line.
•
NO/YES is displayed on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
1009330
CXXX
MXXX
ACTIVATE FUNCTIONS?
NO/YES
B
A
Figure 4.141: Functions
5. Press SELECT (B) until ACTIVATE FUNCTIONS? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
CAUTION
Check to be sure all bystanders have cleared the area.
CAB DISPLAY MODULE