MacDon M155 2022, Руководство оператора

Страница: 227 / 526

215676
207
Revision A
5. Adjust the header angle with HEADER TILT UP switch (E) and/or HEADER TILT DOWN switch (F) on the GSL. The CDM
will display the header angle as a value between 00.0 and 10.0.
NOTE:
Performing this step is not necessary when you want to configure the RETURN TO CUT switch to change only the
header height.
6. Press RETURN TO CUT switch (A) on the CDM. Your settings will be stored in the windrower control module (WCM).
Using Return to Cut Feature
The return to cut (RTC) feature provides preset cutting height and tilt angle settings for the header. When return to cut
mode is enabled, the HEADER UP and HEADER DOWN switches will change the height and angle of the header according to
the stored RTC settings.
1006148
A
B
C
D
E
F
Figure 4.93: Operator Console
A - Return to Cut B - Header Up C - Header Down
D - Display E - Header Tilt Up F - Header Tilt Down
IMPORTANT:
Ensure that the header is engaged and that RETURN TO CUT switch (A) is lit up.
NOTE:
The header can be raised or lowered by PRESSING AND HOLDING HEADER UP switch (B) or HEADER DOWN switch (C) on
the ground speed lever (GSL).
1. If the header is above the preset cutting height, momentarily press HEADER DOWN switch (C) to cause the header to
return to the preset height.
2. If the header is below the preset height, press and hold HEADER UP switch (B) to raise the header. Release the switch
when the header is at the desired height. The CDM will emit a tone when the header rises past the preset height
setting.
OPERATION