MacDon M155 2022, Руководство оператора

Страница: 114 / 526

215676
94
Revision A
To set the rotary disc overload speed:
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.82: CDM Programming Buttons
1. Turn the ignition key to the RUN position, or start the
engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? will appear on the upper line.
NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear.
1009146
CXXX
MXXX
DISC OVERLOAD SPD?
-300 RPM
D
C
B
A
Figure 3.83: Disc Overload Speed
4. Press SELECT (D) until DISC OVERLOAD SPD? appears on the
upper line.
•
The current rotary disc overload speed will appear on
the lower line.
NOTE:
The default setting is -300 rpm. The range of possible disc
overload speeds is -500 to -100 rpm.
5. Press left (B) or right (C) arrows to set the disc overload
speed. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
Setting Hydraulic Overload Pressure
The hydraulic overload pressure setting determines the reported hydraulic pressure at which an overload pressure warning
will appear on the cab display module (CDM). This setting can be changed by accessing the OVERLOAD PRESSURE sub-
menu in the WINDROWER SETUP menu.
NOTE:
•
This procedure requires the installation of the optional hydraulic pressure sensor kit (MD #B5574). For the appropriate
overload pressure value, refer to the pressure sensor installation instructions supplied with the kit.
•
To enable the hydraulic pressure sensor, refer to Enabling or Disabling Header Sensors, page 130 .
OPERATOR
’
S STATION