3. Press soft key 3 (A) to remove or restore the
header
fl
oat.
NOTE:
If the header
fl
oat is active, the icon at soft
key 3 will say REMOVE FLOAT; if header
fl
oat has been removed, the icon will say
RESTORE FLOAT.
Figure 4.162: Adjusting Float – HPT Display
4.5.3 Header Drive
All header controls are conveniently located on the operator’s console and on the ground speed lever (GSL) handle.
NOTE:
Some controls are optional equipment and may not be present in your unit. Some controls may be installed, but
will be nonfunctional for certain headers.
Engaging and Disengaging the Header
The HEADER ENGAGE switch engages and disengages the header drive.
CAUTION
Check to be sure all bystanders have cleared the area.
To Engage Header:
Push and hold HEADER ENGAGE
switch (A) down while pulling up on the collar (B).
To Disengage Header:
Push HEADER ENGAGE
switch (A) down.
Figure 4.163: Header Engage Switch
Reversing the Header
Reverse the header as follows:
214053
185
Revision A
Содержание M1240
