215634
189
Revision B
Predelivery Checklist
Perform these checks and adjustments prior to delivery to your Customer. Complete this checklist and provide it to the
Dealer or the Operator.
CAUTION
Carefully follow the instructions given. Be alert for safety related messages that bring your attention to hazards and
unsafe practices.
Windrower Serial Number:
Engine Serial Number:
M1170
NT5
Windrower Predelivery Checklist
ü
ü
Item
Reference
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
—
Check for loose hardware. Tighten to required torque.
6.3 Torque Specifications, page 178
Check tire air pressures and adjust as required.
4.1.14 Checking Tire Pressure, page 132
Check wheel drive hub lubricant level.
4.1.12 Checking and Adding Wheel Drive Lubricant,
page 131
Check engine coolant level and strength at pressurized
coolant tank.
4.1.6 Checking Engine Coolant Level, page 115
Check air cleaner and clamps.
4.1.3 Checking Engine Air Intake, page 113
Check engine oil level and check for leaks.
4.1.7 Checking and Adding Engine Oil, page 116
Check hydraulic oil level and check for leaks along lines.
4.1.4 Checking and Adding Hydraulic Oil, page 113
Check fuel separator for water and foreign material, drain
and clean as necessary, and add fuel.
4.1.5 Checking Fuel Separator, page 115
Check gearbox lubricant level.
4.1.8 Checking Engine Gearbox Lubricant Level and
Adding Lubricant, page 117
Check tension of A/C compressor belt.
4.1.9 Checking Air Conditioning Compressor Belt,
page 119
Check that machine is completely lubricated.
3.20.2 Grease Points, page 104
Check Operator
’
s Presence System.
4.2.1 Checking Operating Safety System, page 133
Check horn operation.
Check with authorized MacDon Representative on regional
settings for signal lighting logic and speed.
—
Advise customer where to install registration plates.
4.1.2 Advising Customer where to Install
Registration Plates, page 112
Start engine and run to operating temperature.
4.1.10 Starting Engine, page 119
Check HPT, fuel, and diesel exhaust fluid (DEF) gauges for
operation.
4.2.2 Checking Harvest Performance Tracker Display
Gauges, page 134
Check engine speed on HPT.
4.2.3 Checking Engine Speed, page 140
Check that narrow transport
’
s retract and extend features are
functioning properly.
4.2.4 Checking Retract and Extend Functions of the
Narrow Transport System, page 141
Ensure selective catalytic reduction (SCR) conditioning inhibit
is off.
4.2.5 Checking Selective Catalytic Regeneration
Conditioning Mode, page 146
Check that air conditioning and heater are functioning
properly.