MacDon M1170NT5, Руководство оператора

Страница: 97 / 504

215922
77
Revision A
One-Touch-Return Buttons
The One-Touch-Return buttons (A, B, C) on the ground speed lever (GSL) save header configuration settings and serve as
presets for quickly returning the header to specific settings.
1013381
Figure 3.63: One-Touch-Return Buttons on GSL
The One-Touch-Return buttons A, B, and C always save header
height settings, but the following settings can also be saved
depending on the header type:
•
Header tilt
•
Deck position/header float selection
•
Double windrow attachment (DWA) or swath compressor
raise/lower
•
Double Windrow Attachment (DWA) speed
•
Knife speed
•
Draper speed
•
Reel speed
•
Reel height
•
Reel fore-aft
•
Disc speed
To program the One-Touch-Return buttons, press and hold button A, B, or C on the GSL handle for 3 seconds until an
audible tone is heard, indicating that the current header settings have been saved.
NOTE:
To return the header to a preset condition, tap the A, B, or C button quickly. Holding the One-Touch-Return button too long
can inadvertently reprogram the current header settings.
1020173
A
Figure 3.64: One-Touch-Return Buttons on GSL
Pressing a programmed A, B, or C button opens a run screen
that shows corresponding letter (A) on the screen for the
preset.
OPERATOR
’
S STATION