![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032048.webp)
214685
36
Revision A
4.2.1
Converting from Ultra Narrow Configuration or Narrow Configuration
to Medium Configuration
Two kits of MD #287031
1
are required to convert to this configuration.
Figure 4.11: Auger Configurations (Rear View)
1 - Narrow Configuration
2 - Ultra Narrow Configuration
3 - Medium Configuration
Ultra Narrow, Narrow, and Medium auger configurations are
shown at right. When converting from Ultra Narrow
configuration or Narrow configuration to Medium
configuration, you will need to replace the existing
flightings (A) with flightings (B).
1.
To improve access and ease installation, remove float module from combine. For instructions, refer to the
header operator
’
s manual or technical manual.
NOTE:
Some parts have been removed from the illustrations for clarity.
1.
MD #287031 contains wear-resistant flightings, and is available only through MacDon Parts.
Содержание FlexDraper FD1 Series
