214685
259
Revision A
Setting the Sensitivity of the Auto Header Height Control (John Deere 70 Series)
The sensitivity adjustment controls the distance the cutterbar must travel up or down before the auto header height
control (AHHC) reacts and raises or lowers the feeder house. When the sensitivity is set to maximum, only small
changes in ground height are needed to cause the feeder house to raise or lower. When the sensitivity is set to
minimum, large changes in the ground height are needed to cause the feeder house to raise or lower.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
Figure 7.226: John Deere Combine Control
Console
1.
Press button (A) twice and the current sensitivity setting
will appear on the monitor (the lower the reading, the
lower the sensitivity).
2.
Use scroll knob (B) to adjust the sensitivity setting. The
adjustment will be saved automatically.
NOTE:
If the screen remains idle for a short period of time, it
will automatically return to the previous screen.
Pressing the check mark button (C) also will return the
monitor to the previous screen.
Figure 7.227: John Deere Combine Display
NOTE:
The numbers shown on the displays in these
illustrations are for reference purposes only; they are not
intended to represent the specific settings for your
equipment.
Содержание FlexDraper FD1 Series
