![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032203.webp)
214685
191
Revision A
Calibrating the Auto Header Height Control (Case Combines with Version 28.00 or Higher
Software)
For best performance of the auto header height control (AHHC), perform these procedures with the center-link set
to
D
. When setup and calibration are complete, adjust the center-link back to desired header angle. For
instructions, refer to the header operator
’
s manual.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
NOTE:
If header float is set too light, it can prevent calibration of AHHC. You may need to set the float heavier for
calibration procedure so header doesn
’
t separate from the float module.
1.
Ensure header center-link is set to
D
.
2.
Raise header on down stops and unlock float.
3.
Place wings in locked position.
Figure 7.81: Case IH Combine Display
4.
Select TOOLBOX (A) on the MAIN page.
Figure 7.82: Case IH Combine Display
5.
Select the HEAD 1 tab (A).
NOTE:
To locate the HEAD 1 tab, you may need to scroll to the
right using side arrows (B).
Содержание FlexDraper FD1 Series
