214685
142
Revision A
6.16
Lubricating the Header
Table 6.5 Recommended Lubricant
Specification
Description
Use
SAE multipurpose
High temperature, extreme pressure (EP2) performance
with 1% max molybdenum disulphide (NLGI Grade 2)
lithium base
As required unless
otherwise specified
SAE multipurpose
High temperature, extreme pressure (EP) performance with
10% max molybdenum disulphide (NLGI Grade 2)
lithium base
Driveline slip-joints
6.16.1
Greasing Procedure
Greasing points are identified on the machine by decals showing a grease gun and grease interval in hours of
operation. Grease point layout decals are located on the header and on the right side of the float module.
WARNING
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
Figure 6.67: FM100 Grease Point Layout Decal
1.
Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
IMPORTANT:
Use clean, high-temperature, extreme-pressure
grease only.
2.
Inject grease through fitting with grease gun until
grease overflows fitting (except where noted).
3.
Leave excess grease on fitting to keep out dirt.
4.
Replace any loose or broken fittings immediately.
5.
Remove and thoroughly clean any fitting that will not
take grease. Also clean lubricant passageway. Replace
fitting if necessary.
Figure 6.68: FD1 Series Grease Point
Layout Decal
Содержание FlexDraper FD1 Series
