4.2 Installing Disc Segments of Outboard Reel Endshields
To meet the trucking load regulations for the maximum
load width and height, two disc segments of the reel
endshields (A) may have been removed from the
right-hand reel (tail end) and left-hand reel (cam end).
Check if reel endshields are completely installed. If not,
install the two disc segments as follows:
1. Retrieve the bag of hardware removed from the center
draper support.
Figure 4.18: Partially Installed Reel Endshield
(Cam End Shown—Tail End Similar)
2. Remove the two bolts (A) securing the disc segments
to support tabs. Retain for reinstallation later.
3. Engage slots on disc segment (B) on endshield support
tabs (C).
Figure 4.19: Reel Endshield
4. Secure the other end of the disc segment to support
using the bolt (A) that was removed earlier.
5. Position last disc segment (B) in front of disc
segment (C) and behind disc segment (D), engage
endshield support tabs through all disc segments, and
secure with two bolts (E).
NOTE:
It may be necessary to loosen hardware and
use a pry tool to secure the last disc segment
in place.
6. Repeat procedure at the opposite side.
Figure 4.20: Reel Endshield
214047
39
Revision A
