215184
472
Revision A
1027247
A
C
B
Figure 9.369: New Holland Combine Controls
7.
To change one of the memorized header height set points
while the combine is in use, use HEADER HEIGHT AND
HEADER LATERAL FLOAT rocker switch (A) (slow up/down)
to raise or lower header to the desired value. Lightly press
AUTOMATIC HEADER HEIGHT CONTROL button (B) for a
minimum of 2 seconds to store the new height position. A
beep will confirm setting.
NOTE:
Fully pressing AUTOMATIC HEADER HEIGHT CONTROL
button (B) will disengage float mode.
NOTE:
It is not necessary to press rocker switch (C) again after
changing header height set point.
9.1.19
New Holland Combines
–
CR Series
–
2015 and Later
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015 New
Holland combine models, refer to
Checking Voltage Range from the Combine Cab
–
New Holland CR Series
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015 New
Holland combine models, refer to
WARNING
Check to be sure all bystanders have cleared the area.
1.
Position the header 150 mm (6 in.) above the ground, and unlock the float.
