215184
431
Revision A
Adjusting the Manual Header Raise/Lower Rate
–
John Deere 70 Series
The weight of the header will dictate the rate at which the header can be raised or lowered during operation.
To manually adjust the header raise/lower rate, do the following steps:
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
1003636
A
B
C
Figure 9.273: John Deere Combine Control Console
1.
Press button (A) and the current raise/lower rate setting
will appear on the monitor (the lower the reading, the
slower the rate).
2.
Use scroll knob (B) to adjust the rate. The adjustment will
be saved automatically.
NOTE:
If the screen remains idle for a short period of time, it will
automatically return to the previous screen. Pressing check
mark button (C) will also return the monitor to the previous
screen.
1003639
Figure 9.274: John Deere Combine Display
NOTE:
The numbers shown on the displays in these illustrations are
for reference purposes only; they are not intended to
represent the specific settings for your equipment.
9.1.16
John Deere S and T Series Combines
Checking Voltage Range from the Combine Cab
–
John Deere S and T Series
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
WARNING
Check to be sure all bystanders have cleared the area.