215184
224
Revision A
7.4
CLAAS Combines
The D1 Series Draper Header is compatible with CLAAS 500, 600, and 700 Series combines.
7.4.1
Attaching Header to CLAAS Combine
WARNING
To avoid injury or death from unexpected start-up of machine, always stop the engine and remove the key from the
ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1001462
A
B
Figure 7.46: Pins Retracted
2.
Move handle (A) on the float module into the raised
position, and ensure pins (B) at the bottom corners of the
float module are retracted.
1001543
B
A
B
A
Figure 7.47: Header on Combine
WARNING
Never start or move the machine until you are sure all
bystanders have cleared the area.
3.
Start the engine and slowly drive the combine up to the
header until feeder house saddle (A) is directly under float
module top cross member (B).
4.
Raise the feeder house slightly to lift the header, ensuring
the feeder saddle is properly engaged in the float
module frame.
5.
Shut down the engine, and remove the key from
the ignition.
