UNLOADING AND ASSEMBLY
Form 169078
Revision C
34
STEP 17. CONFIGURE HOSE
ROUTING
The header drive hose routing depends on the
windrower model to which the header is being
attached.
a. Press screwdriver against latch in opening (A),
and lift to open header LH drive shield. Shield
will latch at (B) to stay open.
b. Check hose routing at the reel motor.
c. Disconnect hoses as follows:
1. Disconnect hose (C) at tee.
2. Disconnect hose (D) at reel motor.
3. Disconnect tee (E) at motor lower port.
d. Re-connect hoses as follows:
1. Relocate tee (E) to upper port.
2. Connect hose (D) to tee.
3. Connect hose (C) to motor lower port.
e. Close drive shield before engaging header.
STEP 18. REPOSITION WOBBLE
BOX BREATHER
a. Move breather/dipstick (B) to back port, and
install plug (A) in forward port at wobble box(es).
b. Check oil level. Add SAE 85W-140 lubricant if
required.
A
B
CHECK OIL LEVEL WITH TOP OF WOBBLE BOX
HORIZONTAL
BETWEEN LOWER HOLE
AND END OF DIPSTICK
B
A
M100/M205
C
D
E
M150/M200 - FACTORY CONFIGURATION
C
D
E
Содержание A30-D
Страница 53: ...NOTES Form 169078 Revision C 53 ...
Страница 55: ......