26
MSID18-Li
In
more
detail
. . .
Troubleshooting / Recycling and disposal
Problem
Possible cause
Solution
1. Product does not
start
1.1. Forward / reverse
rotation control switch
at center lock position
1.2. Battery pack not
properly attached
1.3. Battery pack discharged
1.4. Battery pack damaged
1.5. Other electrical defect
to the product
1.1. Push forward / reverse
rotation control switch to
left / right
1.2. Attach properly
1.3. Remove and charge battery
pack
1.4. Check by a specialist
electrician
1.5. Check by a specialist
electrician
2. Product does not
reach full power
2.1. Battery pack capacity
too low
2.2. Air vents are blocked
2.1. Charge battery pack
2.2. Clean the air vents
3. Unsatisfactory
result
3.1. Driver bit is worn
3.2. Driver bit not suitable for
intended operation
3.1. Replace with a new one
3.2. Use suitable driver bit
4. Product suddenly
stops
4.1. Product overloaded
4.2. Battery pack discharged
4.3. Battery too hot
4.1. Remove the product from
the workpiece and switch it
on again
4.2. Remove and charge battery
pack
4.3. Remove battery pack and
let it cool down
Recycling and disposal
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local Authority or local store for
recycling advice.
Disposal of an exhausted battery pack
To preserve natural resources, please recycle or dispose of the battery pack
properly. Consult your local waste authority for information regarding available
recycling and/or disposal options. Discharge your battery pack by operating your
tool, then remove the battery pack from the tool and cover the battery pack
connections with heavy duty adhesive tape to prevent short circuit and energy
discharge.
Do not attempt to open or remove any of the components.
