MacAllister 3663602798149, Инструкция и руководство по безопасности, Страница: 8 / 146

EN
7
assembly removed from the tank, place the tank upside down so that the base is facing upwards.
Assemble the feet and the castors according to the following instructions for your model.
CASTOR SYSTEM ASSEMBLY
1. Looking at the bottom of the tank with the vacuum port at the 12 o’clock position use a pencil or
felt tip pen to mark lines marked with an ‘A’ at approximately the 1:30 and 7:30 positions, then a
‘B’ at the 4:30 and 10:30 positions as shown.
2. If the castor feet came bound together, remove the straps and separate them.
3. Align the castor foot marked A with the arrow on the foot.
4. With the arrow on the template also marked A.
5. Place the groove on the foot on the edge of the tank and press until the castor foot is tight
against the base of the tank.
6. Secure the foot using the screws and washers provided.
7. Repeat with feet marked B.
8. Place the motor assembly back on the tank.
SIDE TANK HANDLE ASSEMBLY
Attach side handles to tank with screws provided.
Attach the hose to the vacuum port located on the tank.
The extension tubes slide one inside the other. Twist the extension tubes to lock them in place.
Attach the extension tubes to the accessory end of the hose.
Install the cleaning accessories (as needed) onto the end of the extension tubes.
B
B A
A
Bottom of Tank
A
Arrow
A
Bottom of Tank