800.MACTOOLS
5
WARNINGS
•
The dock is for indoor use only. Do not use in or around water. The lamp can be used outside.
•
Use only the recommended voltage and frequency requirements.
•
Keep out of the reach of children
•
Do not operate dock and lamp with wet hands.
•
Keep lamp away from hot objects
•
Do not place near an open flame
•
Do not crush
•
The distance at which the Out of Range function alarms will activate will vary depending on the
orientation of the dock and any obstructions between the dock and the light. In an automotive or
industrial workplace setting, the average minimum distance to trigger the Out of Range alarms is
100-250ft / 30-75m. To maximize this distance, set the PWR to the maximum setting and mount
the dock flat against a wall with as few obstructions around the dock as possible. We recommend
conducting a physical trial to customize the alarm setting for your workplace.
8 - LOW CHARGE ALERT
•
When the light has 10 minutes of life remaining, the light will flash and the light alarm will activate.
•
To stop the alerts, simply return the light to the charging dock to charge it.
Please note : The Find My Light and Out of Range Function will not work once the light dies.
6 - OUT OF RANGE FUNCTION - POWER (PWR) SETTING
•
You are able to choose the distance at which the Out of Range Function will activate. There are 4
power settings that can be selected depending on the size of the location where the lights will be
used, as shown below,
- To deactivate, press the light power button for 5 seconds and release
after you hear 2 short beeps. The function is deactivated if you hear a further 1 long beep.
•
The Out of Range function is always active on the dock when the dock is plugged in. If you want to
disable the alarm on the dock, you will need to unplug the dock from the wall.
4
5
4
5
4
5
4
5
Min PWR
Mid PWR-1
Mid PWR-2
Max PWR
MAX
MIN
1 = ON / NORMAL
2 = BOOST
3 = OFF
7 - NORMAL USE OF THE LAMP
•
Press the power button once for a normal mode, twice for a boost
mode, three times to turn off the lamp.
CAUTION
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired
operation.
