9
problem
No hot or cold
water.
No water
running out
from taps.
Leakage
from the
bottle supporter
Noisy operation
possible cause
Over consumption of
hot or cold water in
short time
No power supply
Empty bottle
Inlet of bottle
supporter blocked
by bottle seal
Broken bottle
Appliance is not
installed on
a plain surface
troubleshooting
Please check the following before having the appliance repaired.
solution
Just wait a moment,
then hot or cold water
is available again
Connect plug to
socket, tum on
heating or cooling
switch
Replace it with
another one
Clean out wasted
paper & bottle seal,
install bottle again
Replace it with a
new bottle
Place the machine on
a plain & solid surface
appliance installation
warning!
To avoid a hazard due to instability of the appliance,
it must be fixed in accordance with the instructions.
instructions for installation:
1. Use the screw to fix the bracket on the
hole of the middle bottom of the water
dispenser.
2. Make a hole on the floor's(or the desk's
Surface where the water dispenser will be
installed.
3. Fix the bracket on the floor by screwing
tightly.
4. Tighten the screw.
Water dispenser
Bracket
Hole for
tightening screw
