M7 SM-0502, Руководство пользователя

Страница: 21 / 36

21
Note:
It is important to ensure that the Rubber Fitting remains connected to the bleed
screw, and the unit is still pulling a vacuum while the bleed screw is closed. This prevents
air from being sucked back into the wheel cylinder from around the bleed screw threads,
before the bleed screw is tightened and sealed.
Note:
If an automatic refilled kit is not used, be sure to periodically check the level and top
of the brake fluid in the master cylinder.
Instructions for bleeding hydraulic clutch system
Removing old fluid from the clutch master cylinder
IMPORTANT:
The procedures below are to serve as guidelines for the use of this unit, in addition to these
guidelines, always follow the manufacturer’s recommended procedures when servicing
each vehicle.
1. Properly park the vehicle on level ground and turn the
engine off.
2. Clean the exterior of the master cylinder and master cylinder
cap to prevent dirt from entering the master cylinder when the
cap is removed.
3. Remove the cap from the master cylinder reservoir.
4. Connect compressed air 70 psi (4.8 bar) to 170 psi (11.6 bar)
by the nipple attached to the Air Valve
( I ) , located on one
end of the Cover Housing ( A ) .
5. Connect the end of the proper adapter of Extract Tube
( H )
to the Fluid Inlet Cover
( G )
located on the top of the
vacuum bleeder unit.
6. Insert the other end of the Extract Tube
( H ) into the master
cylinder fluid reservoir, then turn the Air Valve ( I ) on, and
press the Push Button ( B ) to start the vacuum (allow a few
seconds for vacuum to build in the bleeder reservoir before
suction occurs). While extracting the old fluid, stir it up to
break loose and remove any sludge that has accumulated
on the bottom and walls of the master cylinder.
7.Once all fluid is removed, turn off the unit and refill the master
cylinder with new manufacturer ’s recommended brake fluid.
Vacuum bleed clutch master cylinder, slave cylinder, and hydraulic lines
Note:
Prior to bleeding, ensure that the master cylinder is full of new manufacture’s
recommended fluid. An automatic refilled kit is included with the unit to maintain the level
of new fluid in the master cylinder during the hydraulic bleeding process. Follow the
instructions included with the kit to prevent air from being sucked into the master cylinder
pistons, slave cylinder, and fluid lines while bleeding the hydraulic clutch system.