M2Tech
www.m2tech.biz
MITCHELL
STEREO ANALOG ELECTRONIC CROSSOVER
REVISION P
RB
– DECEMBER 2020
Copyright © 2020, M2Tech Srl
11
3. Back Panel
S/N:
MADE IN ITALY
MITCHELL
TRIGGER
IN 12VDC
M2TECH
SE OUT A
SE IN
LT
RT
BAL LEFT IN
BAL RIGHT IN
PUSH
PUSH
BAL OUT R
BAL OUT L
LT
RT
DC IN
15V
DC
ELECTRONIC CROSSOVER
SE OUT B
SE OUT C
6
7
8
9
10
11
Figure 2
6) Composite balanced outputs.
Each connector carries three balanced signals from the
outputs of one channel. Use the stock balanced adaptor cables to connect three 3-pin
balanced cables. Connect to the balanced inputs of your power amplifiers. Female 7-pin
XLR connectors.
7) Single-ended outputs.
Connect to the single-ended inputs of your power amplifiers.
Female RCA.
8) Single-ended inputs.
Connect to the single-ended outputs of your preamplifier. When
the
MITCHELL
is set for mono operation, only the left input is used. Female RCA.
9) Balanced inputs.
Connect to the balanced outputs of your preamplifier. Female RCA.
NOTE: choice between single-ended and balanced inputs is done by the app during
set-up.
10) Power input socket.
Connect the stock wall adaptor or the
VAN DER GRAAF MKII
to this
socket
.
Barrel 5.5/2.1mm socket, negative on sleeve.
11) Trigger inputs.
A 12V trigger signal may be sent to this input to switch
MITCHELL
on
and off by the preamplifier or other trigger source. This input has a higher priority than the
front panel switch, therefore the
MITCHELL
will always activate whenever the trigger voltage
is applied and will not switch off as long as the trigger voltage is present, even if the front
panel button is pressed.
