4 Premier M10000 Locomotive Set
Add Smoke Fluid
Figure 2: Adding Smoke Fluid
Smoke Unit
ON/OFF Switch
Figure 3: Smoke Unit Switch Location
Checking The Battery
You may find, if your locomotive was built several months before you set it up, that the
rechargeable battery has run down and needs to be charged before operating. If you
notice that the sounds are garbled, test and charge the engine as described in the
"Self-Charging Battery Back-Up" on page 15.
Running the engine without a primed
smoke unit may cause damage
Assembling The Set
1. Place the engine and cars on straight, level track.
2. Connect the cable between the engine and first car.
3. Press down on the round vestibule over the truck .
4. Slide the tongue on the first car between the depressed vestibule and the truck.
5. Release the vestibule and listen
for the tongue to lock into place.
6. Repeat to connect the second
car
In order to disconnect the cars,
Simply depress the vestibule and
pull the cars apart. Don’t forget to
unplug the cable.
At this point, you are ready to put
your engine on the track and
begin running it.
Depress Car Vestibule While Connecting
Release To Lock The Car In Place
Figure 4: Connecting The Cars
