12
SC100/200 Series Function Block Application Manual EM-6460-C
2.2 READING & SENDING DATA/PARAMETERS
Paths to read or send data and parameters are categorized in the following three types: Path (1) is a basic connecting
method, while Paths (2) and (3) are used to apply a set of parameters at a specific point in the control sequence.
(1) Supplying an output from another function block
Specify Group and Terminal No. (GGNN) of the source block to the destination block input terminal.
(2) Changing parameters at a specific point of control sequence
Register parameters at Parameter Setter function block and send them to a specified block by a sequential control command.
Available parameters depend upon each function block. Refer to the SC100/SC200 Series Function Block List (EM-6460-B).
(3) Changing internal switch values by using Parameter Setter function block
Parameter Setter block can be used to change internal switch values.
function
status
switch
output
parameter
GGNN
I I
NN
NN
NN
GG Function Block
output
NN
GG Function Block
GG I I
GG I I
I I
NN
parameter
parameter
GG Prameter Setter Block
switch
GG Internal Switch Block
sender terminal No.
destination terminal No.
GG : Group No.
(1)
(2)
(3)
(2)
(3)
