1. BEFORE USE ....
Thank you for choosing M-System. Before use, please check contents of the package you received as out-
lined below.
If you have any problems or questions with the product, please contact M-System’s Sales Office or repre-
sentatives.
This product is for use in general industrial environments, therefore may not be suitable for applications
which require higher level of safety (e.g. safety or accident prevention systems) or of reliability (e.g. vehicle
control or combustion control systems).
For safety, installation and maintenance of this product must be conducted by qualified personnel.
■
PACKAGE INCLUDES:
Thermocouple & DC input module (body + CJC sensor) ...............................................................................(1)
Terminating resistor (110 Ω, 0.5 W) ................................................................................................................(1)
■
MODEL NO.
Confirm Model No. marking on the product to be exactly what you ordered.
■
INSTRUCTION MANUAL
This manual describes necessary points of caution when you use this product, including installation, con-
nection and basic maintenance procedures.
The R1C is programmable using the R1X Configurator Software (model: R1CON). For detailed information
on the PC configuration, refer to the R1CON instruction manual. The R1CON PC Configurator Software
is downloadable at M-System’s web site:
R1C-GH
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-5956 Rev.11 P. 2 / 13
