M-system MSP40, Инструкция по эксплуатации

Страница: 15 / 18

MSP40 / MSP50
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EM-4883 P. 15 / 18
MODBUS
ITEM VALUE RANGE
INITIAL
VALUE
PU-2x
R/W SAVE
ADDRESS TYPE ITEM DISPLAY
43 I16 Time ratio (%) of 70 - 80% position * 3 0.0 to 100.0 0.0 22 Pos70R:x R –
44 I16 Time ratio (%) of 80 - 90% position *
3
0.0 to 100.0 0.0 23 Pos80R:x R –
45 I16 Time ratio (%) of 90% - position *
3
0.0 to 100.0 0.0 24 Pos90R:x R –
46 I16 Motor deadlock error
0: Normal
1: Locked when moving upward
2: Locked when moving downward
0 to 2 – 25 Lock:x R –
*2 The operation distance is a distance between the lower-stop position and the upper-stop position.
*3 The time ratio in percentage to the total operation time.
13.4. Clear diagnostics
MODBUS
ITEM VALUE RANGE
INITIAL
VALUE
PU-2x
R/W SAVE
ADDRESS TYPE ITEM DISPLAY
51 I16 Clear total values of the items below.
· Total power-on time (hour)
· Total operation time (hour)
· Total operation distance
· No. of times of motor start actions
· No. of times of motor reverse actions
· No. of times of motor restart
· No. of times when the duty cycle per minute
exceeded 50%
1: Clear
0, 1 0 26 AccumClr:x R/W –
52 I16 Time ratio (%) of respective % positions
1: Clear
0, 1 0 27 PosRClr:x R/W –
53 I16 Clear all diagnostics
1: Clear
0, 1 0 28 DiagAllClr:x R/W –
54 I16 Clear motor deadlock alarm
1: Clear
0, 1 0 29 LockRelease:x R/W –
13.5. Modbus input
MODBUS
ITEM VALUE RANGE
INITIAL
VALUE
PU-2x
R/W SAVE
ADDRESS TYPE ITEM DISPLAY
101 I16 Modbus position setpoint input (%) -5.0 to 105.0 0 – – R/W –
13.6. Modbus operation mode
MODBUS
ITEM VALUE RANGE
INITIAL
VALUE
PU-2x
R/W SAVE
ADDRESS TYPE ITEM DISPLAY
111 I16 Modbus operation mode
(Forcibly returned to ‘0’ when SW1-8=ON)
0: Monitor mode
1: Modbus input mode
2: Configuration mode 0 to 2 0 – – R/W –
[0: Monitor mode]
· R/W registers of addresses up to 111 are readable and writable.
· Registers other than the above are read only.
[1: Modbus input mode]
· R/W registers of addresses up to 111 are readable and writable.
· Registers other than the above are read only.
· When [Input mode= Modbus input], the actuator operates according to [Modbus position setpoint input].
[2: Configuration mode]
· All R/W registers are readable and writable.
· Registers other than the above are read only.
· Operation stops (Actuator operates when a command for starting Auto-setup is entered via Modbus.)