15
73ET/74ET/75ET USERS MANUAL EM-7353-0003B Rev.5
MODEL R1M-P4
The Model R1M-P4 needs hardware setting to specify the display type for either totalized or momentary value.
Figure 1.5.3b: R1M-P4 bottom view.
MODEL RZMS-U9
The Model RZMS-U9 needs hardware setting to specify the A/D conversion mode, service channel numbers, cold
junction compensation, line noise filter frequency, and burnout type for temperature inputs. Cold junction compensa-
tion could be specified on the 7xET program.
Switch Positions
1 through F: At the startup, the combination of settings as shown in the table below is enabled.
0:
PC configuration mode (PC Configuration Software RZMSCFG, under development).
At the startup, last software setting before the power is turned off is enabled.
Figure 1.5.3c: RZMS-U9 rear view.
Table 1.5.3b: RZMS-U9 rotary switch setting.
SW602
SW602 is fixed to
the position 3.
DO NOT CHANGE.
Momentary
SW604
Totalized
(factory default)
Totalized or Momentary
Display Selector
RS-485 Connector
Configurator Jack
Address Setting
Rotary SW
Operating Mode
Setting Rotary SW
RS-232C
9-pin Connector
Power / FG Terminals
A/D
SERVICE
COLD JUNCTION
LINE NOISE
BURNOUT (T/C and RTD)
CONVERSION
CHANNEL
COMPENSATION
FILTER
All Channels
Individual
MODE
NUMBERS
(T/C)
FREQUENCY
NONE
UP
DOWN
Channels
With
50/60 Hz
1
2
3
50 Hz
4
5
6
Medium
12
60 Hz
7
8
9
Without
50 Hz
A
B
C
60 Hz
D
E
F
Software setting
Software setting
Software setting
Software setting
0
for all channels
(12 or 6)
for individual
for all channels
Software
(Fast, Medium, Slow)
channels
(50, 60, 50/60 Hz)
setting
Remark 1: Factory setting is ‘1.’
Содержание 75ET
Страница 24: ...20 7xETBLD USERS MANUAL EM 7353 0003C...