5. COMPONENT IDENTIFICATIONS & HARDWARE ADJUSTMENTS
CN1
A
F
G
L RUN
L ERR.
SD
RD
PWR
5
4
3
2
1
0
9
8
7
6
5
4
3
2
1
0
9
8
7
6
5
4
3
2
1
0
9
8
7
6
D
C
B
E
Terminating Resistor
(accessory)
NAME
FUNCTIONS
A Modular jack for factory calibration
Used only for factory calibration.
MARKING (color)
FUNCTIONS
B Power LED
PWR (green)
ON: Power is supplied.
OFF: Power is not supplied.
C Station No. Setting
Selectable within 1 – 64. (factory set to: 00)
SETTING
BAUD RATE
D Baud rate Setting
0
1
2
3
4
Other than 0 – 4
156 kbps (factory default)
625 kbps
2.5 Mbps
5 Mbps
10 Mbps
Not valid;
L ERR. turns on as a transmission error.
MARKING (color)
FUNCTIONS
E Status indicator LED
L RUN (red)
ON: normal communication
OFF: communication down (time-out error)
L ERR. (red)
ON: transmission data error
Blinking : transmission data error
OFF: normal transmission
SD (red)
ON when transmitting
RD (red)
ON when receiving
F I/O connector
For input and output signals
G Euro type connector terminal for CC-Link For wiring to CC-Link
6. INSTALLATION
Detach the yellow clamps located at the top and bottom of the unit for separating the body from
the base socket.
■
DIN RAIL MOUNTING
Set the base socket so that its DIN rail adaptor is at the bottom. Position the upper hook at the
rear side of base socket on the DIN rail and push in the lower. When removing the socket, push
down the DIN rail adaptor utilizing a minus screwdriver and pull.
■
WALL MOUNTING
Refer to “EXTERNAL DIMENSIONS.”
Clamp
(top & bottom)
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
Shape and size of the base socket
are slightly different with various
socket types.
60C
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-6602 Rev.8 P. 5 / 13
